4 Common Plumbing Dilemmas And How To Address Them

4 Common Plumbing Dilemmas And How To Address Them

Dealing with plumbing problems at home is never a fun experience.

From water leaks to clogged drains, these issues can cause a lot of headaches and messes.

However, by knowing how to address the most common plumbing dilemmas, you can minimize the damage and get your system back on the right track in no time!

This article will discuss some of the most common plumbing problems and how to fix them.

4 Common Plumbing Dilemmas And How To Address Them

When Should You Call a Plumber

If you don’t feel comfortable using a drain rod insert, an auger, or a plunger, and all of your natural methods seem to still leave your drain blocked, then it is time to summon a plumber to help!

To help reduce stress and clean up the mess caused by leaks, plumbing repair in Colorado Springs, Co offers home services.

  1. Clogged Drains And Pipes

A clogged drain or pipe is the most prevalent issue in many homes.

This can be caused by a variety of factors, including hair, food particles, and grease.

There are several ways to deal with this problem, depending on what’s causing it.

If the clog is due to hair, a plunger can often dislodge it.

If the clog is due to food particles or grease, hot water and baking soda can help break up the clog.

As mentioned by the specialists at A-1 Sewer and Septic Service, it’s also important to note that if the clogs are frequent, there could be a problem with your pipes, such as a leak or breakage.

Preventing clogged drains and pipes can sometimes be difficult because you don’t always know what goes down the drain in your home.

However, you can effectively deal with this by putting a drain hole filter in your kitchen and bathroom sinks to catch hair and food particles.

You should also avoid pouring grease down the drain as this will result in blockages.

Make sure to visit mrrooter.com for more information and suggestions in order to figure out how to properly take care of your plumbing system.

With this newfound knowledge, it’s likely that you won’t need as many repairs over time.

You should also avoid pouring grease down the drain as this will result in blockages.

  1. Water Leaks

Another annoying and stressful plumbing issue is a water leak.

Dripping faucets, running toilets, and leaking pipes can waste gallons of water in your home each day.

These leaks may seem minor at the time, but they could significantly increase your monthly utility bills.

If you want this kind of stress to be managed, it’s best to immediately turn off your water supply.

A dripping faucet usually needs to have its washer replaced or have the cartridge removed and reinserted.

In doing this, you should first determine the kind of faucet you have, whether it’s washer-less or a compression type.

A running toilet typically needs to have its flapper valve replaced or adjusted.

Leaking pipes should be inspected by an experienced professional who will decide if the pipe requires tightening, replacing, or repairing with an epoxy resin material to prevent further damage from occurring.

  1. Leaking Faucets

A leaky faucet can be a huge annoyance, whether it’s in your kitchen or bathroom sink.

There are two types of faucets that usually leak: compression and ceramic disc.

The one with a compression-type valve has two washers separated by an adjustable screw and sealed with packing nuts.

The most common reason these leaks occur is that the screws have come loose, which causes water to seep through the gaps between them.

You can fix this problem yourself without calling a plumber if you know what you should do.

Just tighten up those screws! If they’re not tight enough, replace them altogether so you can put everything back in its original state—simple as pie, right?

The ceramic disc-type valve has a washer-less design and is more durable and longer-lasting than the compression type.

However, if the seals wear out over time, then you’ll start to see water dripping from the spout.

The good thing is that its valves are generally easier to fix than those in the compression ones.

All you need to do is replace the seals which can be bought at any hardware store.

So, before you go ahead and call a plumber, make sure to check whether or not it’s a simple fix like this!

Leaking taps aren’t just annoying, they’re also costly because they continuously waste liters upon liters of water.

Not only that, if the water isn’t directed into a drainage system, it can eventually cause damage to your property.

So, make sure you get those leaks repaired as soon as possible!

  1. Frozen Pipes

During the winter, frozen pipes are a common plumbing dilemma. When the water in the pipes freezes, it expands and causes the pipe to burst.

If you suspect frozen pipes, turn on the faucet nearest to it. This will melt the ice and reduce some of the pressure.

You can also use a heat lamp or space heater to thaw out the pipes.

If pipes burst in your house, turn off the water supply at the main valve and call a plumber.

Do not try to fix the broken pipe yourself—you could end up making things worse.

Conclusion

Plumbing issues can cause a lot of damage which can lead to costly repairs.

Thankfully, most of them are preventable with regular maintenance.

If you notice any signs of plumbing problems in your home or business establishment, take action immediately by scheduling an appointment with a professional plumber so the situation doesn’t escalate.